Inflation Guide
In all our fenders and buoys we use a unique strong brass valve for easy inflation and deflation. The best way to inflate a fender is just pushing air pressure from a compressor with a flat head against the valve and the fender will inflate. It also is possible to inflate the fender with a bicycle or car pump with the special Majoni adapter. Do not use a handset with a pin to inflate, because the pin can damage the valve. Best inflation pressure is 0.2 bar / 2.9 psi. This is the pressure where you should be able to press the body of the fender visible easy with your flat hand.
Majoni Adapter
The Special Majoni valve Adapter can be used for:
- Inflating with a bicycle pump
- Inflating with a car pump
- Deflating the fender when pumped too hard
- Pulling out the valve with the pulling aid
- Putting a valve back with the pushing aid
Inflation video
Watch the following instruction video for inflate and deflate a fender or buoy and watch how easily a valve can be replaced.
Video with use of Majoni Adapter
Video with use of pair of thongs
Valve and Adapter
Our unique brass valve for easy inflation and deflation. With the Majoni adapter you can inflate your fender easy with a bicycle or car tire pump. It is not necessary to use an adapter. With enough air pressure, with something like a compressor, the valve will open, and the fender will inflate. To replace a valve, use a bolt M3 and pull it out with a pair of tongs or use the Majoni Adapter with pulling aid
Top Quality made in Holland
All our products are made in the Netherlands with the best selection of top-quality materials. We guarantee the quality of our products with a dedicated quality control system. Materials and suppliers are carefully selected and in our production system several control points are built in to test the products. Our fenders and buoys are made with our own special recipe of a strong UV-resistant marine grade of vinyl.
More then 70 years of excellence is a guarantee for quality.
- Selected top quality materials and suppliers
- Controls all over the process
- Control points from material to packaging
- 24-hour test for each product
- Easy inflation and deflation
Maintenance
Our products require minimal maintenance. If dirty clean with hot water and soap. With proper use, Majoni fenders have proven to protect your boat for more than fifty years.
Recycling
We take care for sustainability and environment with selected materials and a recycling process. The material is low in energy consumption and together with our partners we develop sustainable innovations.